Karlosp.net

1. link

2. link

http://www.pimpmyip.org
Možno da včasih ne dela.

2. možnost
http://vtunnel.com/

Ok, če nič od tega ne dela, potem imajo pa res preklemano dobr security, ampak….

Za vsako skero se štil najde …. Gmail on Karlosp.net

Naj živi svoboda!

Here’s what you need to do to get Cygwin’s X support working:

1. First of all, I’ll assume you’re using Putty as your SSH client. It’s a good free one, but other SSH clients will work, too.

2. Run the Cygwin installer and accept the defaults until you see the following screen:

3. Click the X11 line until it says ‘Install’ and then finish the installation.

4. Go to the newly created Cygwin start menu group and run Cygwin Bash Shell. After the command prompt starts up, type ‘exit’ to close the window.

IMPORTANT: Even though you may never want to use Cygwin’s Linux-like environment, you MUST start it up at least once before trying to use X. Skipping this step will leave Cygwin stuck in an unusable state – trust me.

5. Cygwin comes with a handy batch file called ‘startxwin.bat’ for starting the X server. By default, it also opens a terminal window to the Cygwin environment. Since you won’t be using that terminal window, you can prevent it from opening by adding REM before the following line near the bottom of startwin.bat (located here on my system C:\cygwin\usr\X11R6\bin):

%RUN% xterm -e /usr/bin/bash -l

6. Now make a shortcut to startwin.bat if you want and run it. You should see an X in the system tray at this point.

7. The only thing left to do is enable X11 forwarding in Putty as show below. Keep in mind that this is not a global setting, so you’ll need to make this change (and save it) for each saved session.

X11 forwarding in Putty

8. Now connect to your linux system and run ‘xclock &’ to see if it works.

xclock on Windows

9. to je to!

start.exe

Preprost in zastonjski program za delanje print screen
http://www.gadwin.com/download/ps_setup.exe

Download fValidate

vir

RealVNC viewer

Ostali ukazi sistema LINUX

tar in gzip: Arhiviranje datotek

Programa tar in gzip se uporabljata za arhiviranje in stiskanje datotek na LINUX-u.

Nov arhiv ustvarimo z ukazom:

tar -czf arhivska_datoteka.tar.gz datoteka [datoteka2]

(opcija -z pomeni, da arhiv tudi stisnemo s programom gzip)

Vsebino arhiva izpišemo z ukazom:

tar -ztf arhivska_datoteka.tar.gz

Arhiv odpakiramo z ukazom:

tar -xzf arhivska_datoteka.tar.gz